Cleaning Victorian Tiles
We set about cleaning the tile using Tile Doctor Remove and Go which is a strong coatings remover which is ideal for removing old sealers and adhesive products. It was left it to seep in the floor for a while in order to give it chance to soak into the tile and get to work on the glue before being agitated using a rotary machine fitted with a black scrubbing pad. The dirty solution was then removed using a wet vacuum and the floor given a good rinse with clean water again using the wet vacuum to get the floor dry. This process tackled the glue but the tiles were still in need of a good clean so Tile Doctor Pro-Clean which is a strong alkaline cleaning product safe to use on tile and stone was applied; this was left to dwell and then scrubbed into the tiles to get a really deep clean, stiff brushes were used along the grout lines to get them clean as well and then the floor was given a thorough rinse to neutralize the tile and remove any trace of cleaning products.
Sealing Victorian Tiles
Finally it was time to seal the floor, however the tiles need to be dry before you can do this so we got our Turbo drying system out of the van, switched it on and it soon had the floor dry. Four coats of Tile Doctor Seal and Go were applied to the floor allowing twenty minutes to dry between coats; this particular sealer is recommended for Victorian tiles and does a great job of adding a nice sheen to the floor as well as adding stain protection.
We managed to complete the work in a single day and the owner was absolutely delighted by the results.