Restoring an Old Brick Floor in Oxford

We were contacted by a customer living in Oxford who had a property with a brick floor in the living room that was in a bad state and in need of restoration. Brick has always been used as an alternative flooring material to stone due its durability and low cost. Oxford has a long history dating back over a thousand years so it not unusual to discover something like this in older properties. The owner believed the floor to be over 100 years old and had been patched up in numerous places in the past with holes filled in with modern bricks and concrete. I was confident we could dramatically improve the floor but naturally give its long history it would never look like it was new again.

Restoring a Brick Floor

To remove the dirt I stated with the application of a strong dilution of Tile Doctor Pro Clean, a high alkaline product that is our go to cleaning product. I applied the product to the floor and left it to dwell for twenty minutes before scrubbing into the brick with a black scrubbing pad fitted to a low speed rotary machine. The soiled cleaning solution was then extracted using a wet vacuum and the floor rinsed with water. With a lot of the dirt removed I could see I would need to use something abrasive to remove the layers of concrete and give the floor a consistent appearance. Fortunately we a number of techniques we can use for dealing with these issues and in this case I opted to apply a series of coarse abrasive milling pads. I started with the 50grit grit pad which is applied by attaching it to a weighted floor buffer and lubricated with water. Then the floor is rinsed and the process repeated with a 100 grit pad and finally a 200 grit pad to finish the process. The pads use industrial diamonds to slowly grind down the surface and improve its appearance. After the final rinse I could see the floor was much improved, I then had to wait for the floor to dry off fully before I could seal it.

Sealing a Brick Floor

On my return the next day I checked the floor with a damp meter to make sure it had dried. All was well so I set about applying a sealer to protect the floor from staining going forward and also make it easier to clean. This sealer I opted for was Tile Doctor Colour Grow which protects the brick from within by become ingrained into the pores of the material and has the added benefit of enhancing the natural colour to bring back the redness of the brick in the process.


I appreciate the photographs are not my best but hopefully you can appreciate the improvement, certainly the customer was very pleased with transformation and left the feedback for me below. In fact they were originally of the opinion that it probably wasn’t salvageable so this was a major bonus. We went from dirty old brick living room floor to shiny new (looking) floor in the space of two days. Barry called back immediately came round to have a look the same day then set a date and time and met every promise.


Source: Brick Tile Cleaning and Restoration Service in Oxford