Slate Tiled Shower Cubicle Restoration in Oxfordshire

Just Southwest of Bicester, Kidlington is one of the largest villages in England with a population of nearly 14,000. There are a lot of amenities, making it a great place for families to make their homes and I recently visited the area to see a customer with a Slate tiled shower cubicle in need of restoration.


It’s not unusual to get asked to restore natural stone shower cubicles because they can suffer with mould, water marks and Limescale issues and can easily get into poor condition. Quite a lot of these problems can be avoided by rinsing the tiles down after a shower to remove traces of shampoos and soaps and ensuring the room has adequate ventilation. If you want to read more on this subject take a look at http://shower.tilecleaning.co.uk/

Cleaning a Slate Tiled Shower Cubicle

The first process involved in restoring this cubicle was to cover the entire area in Tile Doctor Remove and Go, which is a multi-purpose cleaner designed to strip away any old sealers, synthetic finishes, adhesives and paint stains. It also helps to draw out ingrained stains and remove heavy grease build-up. The product was left to dwell for roughly ten minutes before I scrubbed it into the tiles and grout with a stiff hand brush. Next, I rinsed the area with water to remove traces of chemicals and wiped it dry with a cloth. Following this, I covered the tiles with Tile Doctor Grout Clean-Up, which is a concentrated phosphoric acid cleaner formulated to remove grout smears and mineral deposits such as Limescale. The product was scrubbed into the grout a couple of times, before the area was rinsed again with water and wiped dry with a cloth. Grout Clean-up is an acidic product and so shouldn’t be left on stone for too long as it can damage it.

Sealing a Slate Tiled Shower Cubicle

To seal the Slate, I used Tile Doctor Stone Oil, which is an easy-to -apply, impregnating sealer that is particularly effective on low porosity stone. It is formulated to restore the naturally dark colour and patina in the stone. To finish I applied a single coat of Tile Doctor Ultra Seal which is an impregnating sealer that gives a natural look finish to the slate. I applied the sealer with a lint-free cloth, left it for about 30 minutes to cure and then wiped off any excess with a clean cloth.


The results were fantastic and the customer was especially pleased with the clean, natural look the sealer had given the Slate.


Source: Slate Tile Cleaning and Restoration Service in Oxfordshire