Cleaning a Slate Floor
The first step was to sweep up all the loose debris from the floor; we scrub the floor quite hard during our work so it’s important to remove any grit that could scratch the surface of the tile. We then mixed a dilution of Tile Doctor Remove and Go 50/50 with Nanotech Ultra Clean and began to work the solution into the floor allowing it to dwell for around an hour first (This process helps to soften and break down the remains of the sealer on the stone). We used a hard deck scrubber to agitate the chemicals and loosen the dirt and old sealer from the floor which is then extracted from the surface using a wet vacuum and rinsed down with clean water several times to make sure all chemicals are removed. The next step was to apply a dilution of Tile Doctor Grout Clean-up which was then scrubbed the floor once again with hard deck scrubber. This broke down and removed all of the cement/ grout haze that the installer had left over the surface of the tile, again the floor was then rinsed with water and extracted to remove any chemical residue. The floor was scrubbed again this time using a dilution of Tile Doctor Pro-Clean to make sure all old sealer, cement, grout haze and dirt had been completely removed. We then give the floor a thorough and final rinse and mopped the tiles with Neutral Tile Cleaner to neutralise any remaining trace of chemicals and removed the solution using the wet vacuum before leaving the floor to dry overnight.Sealing a Slate Floor Sealing
Once the floor was dry it was then sealed using five coats of Tile Doctor Seal and Go which was chosen to provide the desired finish that the customer wanted.
Source: Help cleaning Slate tiled floors
